Send document comments to nexus7k-feedback-doc@cisco.com
2-703
Cisco NX-OS System Messages Reference
OL-15994-03
Chapter 2 System Messages and Recovery Procedures
SYSMGR Messages
Error Message SYSMGR-3-LC_SAVE_STATES_FAILURE: Save states request for the linecard
failed(error-id [hex]).
Explanation Save state request for the line card failed.
Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Support web site http://www.cisco.com/tac.
Error Message SYSMGR-3-LC_STOP_ASYNC_FAILURE: Stop async notification request
failed(error-id [hex]).
Explanation Stop asynchronizationnotification request for the line card failed.
Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Support web site http://www.cisco.com/tac.
Error Message SYSMGR-3-LC_UPG_ERROR: LC ERROR: [chars]
Explanation Linecard upgrade error message.
Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Support web site http://www.cisco.com/tac.
Error Message SYSMGR-3-MISSING_OPTIONAL_CAPABILITY: Incomplete support for the
current running-config on standby supervisor.
Explanation Loose config incompatibilities exist between active and standby sup. Operational
redundancy mode is still set to HA.
Recommended Action No action is required.
Error Message SYSMGR-3-MODULE_LOCK_FAILED: Failed to lock the local module to avoid
reset (error-id [hex]).
Explanation Locking the local module has failed. Reloading the local module can now result in
switchover to fail.
Recommended Action No action is required.
Error Message SYSMGR-3-ND_UPGD_RECOVERY_SRVFAILED: Service [chars] in vdc [dec]
failed in non-disruptive upgrade recovery (error-id [hex]).
Explanation The nondisruptive upgrade failed because a service could not recover its state.
Recommended Action No action is required.
To Next Page
Loading...
Need help?
General
