Send document comments to nexus7k-feedback-doc@cisco.com
2-704
Cisco NX-OS System Messages Reference
OL-15994-03
Chapter 2 System Messages and Recovery Procedures
SYSMGR Messages
Error Message SYSMGR-3-OPERATIONAL_MODE_WARM: Operational redundancy mode set to
warm (error-id [hex]).
Explanation Operational redundancy mode will be set to warm. [dec] is the error-ID representing
the reason.
Recommended Action No action is required.
Error Message SYSMGR-3-PARTIAL_CFGWRITE_FAILED: Partial configuration copy failed
(error-id [hex]).
Explanation The requested configuration copy has failed. [dec] is the error-ID representing the
failure reason.
Recommended Action No action is required.
Error Message SYSMGR-3-PARTIAL_CFGWRITE_VER_MISMATCH: Startup-config version not
same as current software version.
Explanation Startup-config version not same as current software version.
Recommended Action Do a copy running startup, and try again.
Error Message SYSMGR-3-RTDBCTRL_SRVFAILURE: Service [chars] responded with a
failure
Explanation A service responded with a failure to the request.
Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Support web site http://www.cisco.com/tac.
Error Message SYSMGR-3-RTDBCTRL_SRVTIMEOUT: Service [chars] failed to respond back
to System Manager in the specified timeout period
Explanation A required service has failed to send a response after receiving a request for the fabric
switch upgrade.
Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Support web site http://www.cisco.com/tac.
Error Message SYSMGR-3-SERVICE_TERMINATED: Service [chars] (PID [dec]) has finished
with error code [chars] ([dec]).
Explanation A service has terminated its execution normally. Depending on the value of [dec2] and
the HA policies implemented for the service, the service might be restarted automatically.
Recommended Action No action is required.
To Next Page
Loading...
Need help?
General
