Cisco AP775A - Nexus Converged Network Switch 5010 Reference

Send document comments to nexus7k-feedback-doc@cisco.com
2-767
Cisco NX-OS System Messages Reference
OL-15994-03
Chapter 2 System Messages and Recovery Procedures
URIB Messages
Error Message URIB-3-INCONSISTENT_SUMMARY Format: %s: routes %d, rnh's %d
Explanation Unexpected remaining state for client during RIB cleanup. Use the 'show routing ipv4
unicast internal event-history errors' command for more information.
Parameters: Owner, Routes, RNHs ...
Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Support web site http://www.cisco.com/tac.
Error Message URIB-3-INSTANCE_CREATE_ERROR Format: Failed to create routing
instance info for client \%s\, VRF %s
Explanation URIB could not create its data structures for a client in the shown VRF. There may be
further errors to indicate the failure in more detail. The shown VRF should be reconfigured in the
client. i.e. in router sub-mode configuration, 'no vrf <vrf-name>'
Parameters: Client, VRF ...
Recommended Action Requires operator to intervene.
Error Message URIB-3-KSINK_LIB_ERROR Format: %s %s
Explanation A error was encountered during ksink operations. The system may run into more errors
because of this problem.
Recommended Action No action is required.
Error Message URIB-3-MORE_INFO_ERROR Format: Client \%s\: %s
Explanation This error provides further information about the previous error. Action should be taken
depending on the previous error logged.
Parameters: Client, Message ...
Recommended Action No action is required.
Error Message URIB-3-MORE_MTS_INFO_ERROR Format: source SAP is: %d dest SAP is: %d
Explanation This error provides further information about the previous MTS error. Action should be
taken depending on the previous MTS error logged.
Recommended Action No action is required.
Error Message URIB-3-MTS_BIND Format: mts_bind failed for %s: %s
Explanation URIB was unable to bind to an MTS queue SAP, causing an unrecoverable error.
Parameters: MTS queue name, Error ...
Recommended Action Use 'reload' command to reload the system. Be aware that this problem affects
all VDCs on the system.

Cisco AP775A - Nexus Converged Network Switch 5010 Specifications

General

Brand	Cisco
Model	AP775A - Nexus Converged Network Switch 5010
Category	Switch
Language	English