Send document comments to nexus7k-feedback-doc@cisco.com
2-768
Cisco NX-OS System Messages Reference
OL-15994-03
Chapter 2 System Messages and Recovery Procedures
URIB Messages
Error Message URIB-3-MTS_DEREGISTER Format: mts_deregister failed for urib: %s
Explanation URIB was unable to deregister client from URIB notifications, causing an
unrecoverable error.
Recommended Action Use the 'restart' command to restart the feature and clear this problem.
Error Message URIB-3-MTS_DROP Format: Error returned from mts_drop(), error: %s
Explanation An MTS API returned an error when URIB tried to drop a message.
Recommended Action No action is required.
Error Message URIB-3-MTS_NO_CLIENT_SAP Format: %s: client \%s\ has not provided a
SAP for ack
Explanation A client registered with URIB, but did not provide a SAP for URIB to send reply
messages to. This caused an unrecoverable error.
Recommended Action Use the 'restart' command to restart the feature and clear this problem.
Error Message URIB-3-MTS_NO_PAYLOAD_ERROR Format: Received MTS message with no
payload on %s queue with opcode %d, dropping it
Explanation URIB received an unknown message. The message is dropped.
Recommended Action No action is required.
Error Message URIB-3-MTS_OPTIONS Format: MTS option set failed for opcode %s: %s
(%d)
Explanation URIB was unable to set options for an MTS opcode
Parameters: Requestor, Error String, Error ...
Recommended Action Use the 'system switchover' command to switch over to the standby supervisor.
If no standby is present, or the standby is not ready, use the 'reload' command to reload the system.
The state of the standby can be checked using the 'show system redundancy ha status' command.
Error Message URIB-3-MTS_RECV Format: Error returned from mts_recv(%s), errno: %s
Explanation An MTS API returned an error while URIB was receiving on an MTS queue.
Parameters: Queue name, Error ...
Recommended Action No action is required.
To Next Page
Loading...
Need help?
General
