Send document comments to nexus7k-feedback-doc@cisco.com
2-49
Cisco NX-OS System Messages Reference
OL-15994-03
Chapter 2 System Messages and Recovery Procedures
BGP Messages
Error Message BGP-3-ASSERT Format: %s:%d: Assertion `%s' failed.
Explanation An internal software error occurred.
Parameters: File Name, Line Number, Assert Type ...
Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Support web site http://www.cisco.com/tac.
Error Message BGP-3-ATTRAVL_OP Format: Failed attribute external database
operation: %s, id %lu
Explanation BGP was unable to perform an attribute external database operation
Parameters: Operation, Attr ID ...
Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Support web site http://www.cisco.com/tac.
Error Message BGP-3-ATTRID_OP Format: Failed to %s attribute ID
Explanation BGP was unable to allocate or free an index for a BGP PATH attribute block
Parameters: Allocate or free ...
Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Support web site http://www.cisco.com/tac.
Error Message BGP-3-BADPEERAS Format: VRF %s, Peer %s - bad remote-as, expecting %s
received %s.
Explanation The system has detected an error when prepending to an AS path.
Parameters: Segment Type, Segment Length ...
Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Support web site http://www.cisco.com/tac.
Error Message BGP-3-BRIB_ADD_INT Format: Internal error in adding to BRIB: %s
Explanation An internal error has occurred when the system attempted to a path to the BRIB. The
BGP process may have run out of memory.
Parameters: Error ...
Recommended Action If BGP ran out of memory, add memory to the router or change the network
configuration to decrease memory requirements. Clear any BGP peers that may have been shut down
automatically. If BGP has available memory, restart BGP.
To Next Page
Loading...
Need help?
General
