Cisco AP775A - Nexus Converged Network Switch 5010 Reference

Send document comments to nexus7k-feedback-doc@cisco.com
2-50
Cisco NX-OS System Messages Reference
OL-15994-03
Chapter 2 System Messages and Recovery Procedures
BGP Messages
Error Message BGP-3-BRIB_RDADD Format: [%s] Couldn't add rdinfo %s to BRIB
Explanation BGP was unable to add a prefix to the BGP RIB. The BGP process may have run out
of memory.
Parameters: Address-family, RDinformation...
Recommended Action If BGP ran out of memory, add memory to the router or change the network
configuration to decrease memory requirements. Clear any BGP peers that may have been shut down
automatically. If BGP has available memory, restart BGP.
Error Message BGP-3-BRIBADD Format: [%s] Couldn't add dest to BRIB for %s/%d
Explanation BGP was unable to add a prefix to the BGP RIB. The BGP process may have run out
of memory.
Parameters: Address-family, Prefix/masklength ...
Recommended Action If BGP ran out of memory, add memory to the router or change the network
configuration to decrease memory requirements. Clear any BGP peers that may have been shut down
automatically. If BGP has available memory, restart BGP.
Error Message BGP-3-BRIBDEL Format: [%s] Couldn't delete dest from BRIB for %s/%d
Explanation An unexpected but recoverable event has occurred.
Parameters: Address-family, Prefix/masklength ...
Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Support web site http://www.cisco.com/tac.
Error Message BGP-3-CLISET Format: Unable to set %s inheritance for %s
Explanation An internal software error occurred.
Parameters: Template type, Peer address ...
Recommended Action Use the 'restart' command to restart the feature and clear this problem.
Error Message BGP-3-COMADD Format: Error occurred in community addition, no action
taken
Explanation An internal error has occurred when the system attempted to a community.
Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Support web site http://www.cisco.com/tac.
Error Message BGP-3-COMLEN Format: Community sets exceeded maximum allowed limit
Explanation An internal limit was reached when the system attempted to a community.
Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Support web site http://www.cisco.com/tac.

Cisco AP775A - Nexus Converged Network Switch 5010 Specifications

General

Brand	Cisco
Model	AP775A - Nexus Converged Network Switch 5010
Category	Switch
Language	English