Cisco AP775A - Nexus Converged Network Switch 5010 Reference

Send document comments to nexus7k-feedback-doc@cisco.com
2-52
Cisco NX-OS System Messages Reference
OL-15994-03
Chapter 2 System Messages and Recovery Procedures
BGP Messages
Error Message BGP-3-FINDAGGR Format: [%s] Did not find aggregate path for entry
%s/%d
Explanation BGP was unable to find an internal datastructure for originating a configured aggregate.
Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Support web site http://www.cisco.com/tac.
Error Message BGP-3-ILLARGS Format: %s called with illegal arguments
Explanation An internal software error occurred.
Parameters: Function ...
Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Support web site http://www.cisco.com/tac.
Error Message BGP-3-INTERNAL Format: Internal error %d: %s
Explanation An internal software error occurred.
Parameters: Error Type, Error ...
Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Support web site http://www.cisco.com/tac.
Error Message BGP-3-INVHDR Format: Peer %s sent unexpected header pattern
Explanation The marker pattern in the message header was invalid.
Recommended Action Check that the peer router is configured correctly. Clear the peer if necessary
after any change.
Error Message BGP-3-IPTOS Format: Unable to set IP TOS bits for %s, fd %d
Explanation An unexpected but recoverable event has occurred.
Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Support web site http://www.cisco.com/tac.
Error Message BGP-3-LIST Format: %s
Explanation An internal software error occurred.
Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Support web site http://www.cisco.com/tac.

Cisco AP775A - Nexus Converged Network Switch 5010 Specifications

General

Brand	Cisco
Model	AP775A - Nexus Converged Network Switch 5010
Category	Switch
Language	English