EasyManuals Logo

Cisco AP775A - Nexus Converged Network Switch 5010 Reference

Cisco AP775A - Nexus Converged Network Switch 5010
886 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #92 background imageLoading...
Page #92 background image
Send document comments to nexus7k-feedback-doc@cisco.com
2-54
Cisco NX-OS System Messages Reference
OL-15994-03
Chapter 2 System Messages and Recovery Procedures
BGP Messages
Error Message BGP-3-MTSSEND Format: MTS send() error to SAP %d, opcode %d: %s
Explanation An unexpected but recoverable event has occurred.
Parameters: MTS SAP, MTS Opcode, Error ...
Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Support web site http://www.cisco.com/tac.
Error Message BGP-3-NBRERR Format: %s Peer error: %s
Explanation An internal software error occurred.
Parameters: Peer address, Error ...
Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Support web site http://www.cisco.com/tac.
Error Message BGP-3-NEGWRITE Format: Negative nr of %d bytes left to write to peer %s
Explanation An internal software error occurred.
Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Support web site http://www.cisco.com/tac.
Error Message BGP-3-NEXTHOPADD Format: [%s] Couldn't add next-hop to RNHDB for
%s/%d, error %d
Explanation The router was unable to store a BGP next hop in an internal database, because it ran
out of memory.
Parameters: Address-family, Prefix/masklength, Error ...
Recommended Action If BGP ran out of memory, add memory to the router or change the network
configuration to decrease memory requirements. Clear any BGP peers that may have been shut down
automatically. If BGP has available memory, restart BGP.
Error Message BGP-3-NEXTHOPDEL Format: [%s] Couldn't delete next-hop from RNHDB for
%s/%d, error %d
Explanation An unexpected but recoverable event has occurred.
Parameters: Address-family, Prefix/masklength, Error ...
Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Support web site http://www.cisco.com/tac.
Error Message BGP-3-NOBUF Format: [%s] Unable to get buffer for %s msg to peer %s
Explanation An internal software error occurred.
Parameters: Address-family, Msg Type, Peer address ...
Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Support web site http://www.cisco.com/tac.

Table of Contents

Other manuals for Cisco AP775A - Nexus Converged Network Switch 5010

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco AP775A - Nexus Converged Network Switch 5010 and is the answer not in the manual?

Cisco AP775A - Nexus Converged Network Switch 5010 Specifications

General IconGeneral
BrandCisco
ModelAP775A - Nexus Converged Network Switch 5010
CategorySwitch
LanguageEnglish

Related product manuals