Send document comments to nexus7k-feedback-doc@cisco.com
2-56
Cisco NX-OS System Messages Reference
OL-15994-03
Chapter 2 System Messages and Recovery Procedures
BGP Messages
Error Message BGP-3-PLCYOUT Format: Cannot add reference to policy out info for
route-map %s
Explanation Use the 'restart' command to restart the feature and clear this problem.
Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Support web site http://www.cisco.com/tac.
Error Message BGP-3-PLCYRNHATTACH Format: Couldn't attach to policy RNH info for
policy %s, error: %s
Explanation An internal error occurred in using a policy. BGP_EXPL_NO_MEM_MAYBE.
Recommended Action If BGP ran out of memory, add memory to the router or change the network
configuration to decrease memory requirements. Clear any BGP peers that may have been shut down
automatically. If BGP has available memory, restart BGP.
Error Message BGP-3-PLCYRNHDETACH Format: Couldn't detach from policy RNH info for
policy %s, error: %s
Explanation An internal software error occurred.
Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Support web site http://www.cisco.com/tac.
Error Message BGP-3-PLCYRNHSETUP Format: Couldn't setup rnh notifications for
policy %s, error: %s
Explanation An internal error occurred in using a policy. BGP_EXPL_NO_MEM_MAYBE.
Recommended Action If BGP ran out of memory, add memory to the router or change the network
configuration to decrease memory requirements. Clear any BGP peers that may have been shut down
automatically. If BGP has available memory, restart BGP.
Error Message BGP-3-RDINFO Format: VRF %s, %s, table %s: rdinfo %s failed
Explanation BGP was unable to initialize an internal datastructure. The BGP process may have run
out of memory.
Parameters: VRF name, Address-family, Table name, Operation ...
Recommended Action If BGP ran out of memory, add memory to the router or change the network
configuration to decrease memory requirements. Clear any BGP peers that may have been shut down
automatically. If BGP has available memory, restart BGP.
Error Message BGP-3-RESTARTINIT Format: Unable to determine restart status and
initialize
Explanation An unrecoverable error has occurred during BGP initialization.
Recommended Action Use the 'restart' command to restart the feature and clear this problem.
To Next Page
Loading...
Need help?
General
