iView - Controller View
9-142 Manual # 42-02-7223
Switch priority, door operation, car call disposition and more are configured on the
iView Configuration > Car Operation > Elevator recall tab.
• Retiring Cam: This output is turned ON to lock the hoistway doors if all doors (front
and rear) are fully closed and there is a demand to move the car. Otherwise it is OFF.
This output is turned OFF if the car is stopped in between floors.
• Sabbath Interval Finished: This output turns on to indicate that the car has finished a
Sabbath Mode Interval trip, but Sabbath mode is still enabled.
• Sabbath Operation Indicator: This output is on when the car is on Sabbath operation
(Configuration > Car Operation > Sabbath operation tab).
• Security Code Entry Mode Main COP: This output is on when the car is waiting for a
security code to be entered at the main Car Operating Panel.
• Security Code Entry Mode Aux COP: This output is on when the car is waiting for a
security code to be entered at the auxiliary Car Operating Panel.
• Seismic Switch: Activated when the seismic switch circuitry on the Earth Quake (ICE-
IEQ) board is latched. Remains on until the Reset switch on the EQ board is pressed.
• Shuttle service: This output is on when the car is on Shuttle service (Configuration >
Car Operation > Shuttle service tab).
• Silent mode: This output is on when Silent mode is ON (Controller > Configuration >
Car Operation > Devices).
• Swing Operation Indicator: This output is on when the car is on Swing operation. Hall
call service is based on parameters set on the Configuration > Swing Configuration
tabs. Automatic swing operation is enabled on the Configuration > Car Operation >
Passenger tab. Car call eligibility is set on the Configuration > General > Car call eligi-
bility tab.
• Test Mode: Active when the car is on Test mode operation.
• Front Door — Rear Door
• Front (Rear) Car Gong: This output is activated to announce the elevator's intention to
go up or down after the car steps into a floor by sounding the front or rear car gong.
Timer options located on Configuration > Car Operation > Devices tab.
• Front (Rear) Closing Warning Buzzer: This output is turned ON after the Closing
warning light timer has elapsed (see Front (Rear) Closing Warning Light). The Clos-
ing warning buzzer timer, on the Configuration > Car Operation > Doors > Front or
Rear tab, determines the amount of delay after the Front (Rear) Closing Warning
Buzzer output is turned ON before automatic closing of the front or rear doors begins.
Total door closing delay is the sum of the closing warning light and buzzer times.
The door close warning buzzer is required for power operated vertically sliding doors
whenever they are closed automatically or with momentary pressure. It must come on
at least 5 seconds prior to the start of closing and stay on until the front/rear doors are
closed. For momentary pressure closing, when the in-car front/rear door close button
is pressed, the 5 second closing delay may be omitted.
• Front (Rear) Closing Warning Light: This output is turned ON prior to the Front
(Rear) Closing Warning Buzzer output being turned ON. The Closing warning light
timer, on the Configuration > Car Operation > Doors > Front or Rear tab, determines
the amount of delay before the Front (Rear) Closing Warning Buzzer output is turned
ON. This output remains ON until the doors are fully closed.
• Front (Rear) DCLC Output: This output turns ON when the front (rear) car gate and
hoistway doors are closed.
To Next Page
Loading...
Need help?
General