Viewing spectral calibration or install run results in the Remote Monitoring
softwar
e
When viewing results for spectral calibration or install runs in the Remote Monitoring software, only raw
data is displayed.
Spectr
al calibration or install run plates are not added to the Run History tab or the Cloud Analysis
tab.
For information on viewing spectral calibration or install run results on the instrument, see Chapter 12,
“Run calibrations and install checks”.
Use cloud analysis in the Remote Monitoring software
Automated cloud analysis with secondary analysis software
The automated cloud analysis feature allows the instrument to send data to Thermo Fisher
™
Connect
for secondary analysis. You can specify one or more Thermo Fisher
™
Connect cloud applications for the
analysis.
Cloud analysis can be set up before or after a plate is run.
•
Before a plate is run—Create a plate file in the Plate Manager software (cloud) and enable cloud
analysis. See “Set up cloud analysis in the Plate Manager software (cloud)” on page 124 and “Plate
file requirements for viewing analyzed and cloud results” on page 187.
•
After a plate is run—Select a plate in the SeqStudio
™
Flex Remote Monitoring software, then
specify cloud analysis. See “Set up cloud analysis for a completed run in the Remote Monitoring
software” on page 205.
To use the cloud analysis feature, Thermo Fisher
™
Connect access must be enabled on the instrument.
See Chapter 9, “Use the instrument with Thermo Fisher
™
Connect”.
Chapter 8 Use the Remot
e Monitoring software to monitor runs, view results, and use cloud analysis
Use cloud analysis in the Remote Monitoring software
8
202
SeqStudio
™
Flex Series Genetic Analyzer with Instrument Software v1.0 User Guide
To Next Page
Loading...
