Agilent Technologies InfiniiVision 5000 Series Programmer's Guide

Commands by Subsystem 5
Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide 101
*CLS (Clear Status)
(see page 658)
Command Syntax
*CLS
The *CLS common command clears the status data structures, the
device-defined error queue, and the Request- for- OPC flag.
See Also • "Introduction to Common (*) Commands" on page 99
• "*STB (Read Status Byte)" on page 117
• "*ESE (Standard Event Status Enable)" on page 102
• "*ESR (Standard Event Status Register)" on page 104
• "*SRE (Service Request Enable)" on page 115
• ":SYSTem:ERRor" on page 394
NOTE
If the *CLS command immediately follows a program message terminator, the output queue
and the MAV (message available) bit are cleared.

Agilent Technologies InfiniiVision 5000 Series Specifications

General

Brand	Agilent Technologies
Model	InfiniiVision 5000 Series
Category	Test Equipment
Language	English