250 Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide
5 Commands by Subsystem
:HARDcopy:FFEed
(see page 658)
Command Syntax
:HARDcopy:FFEed <ffeed>
<ffeed> ::= {{OFF | 0} | {ON | 1}}
The HARDcopy:FFEed command controls whether a formfeed is output
between the screen image and factors of a hardcopy dump.
ON (or 1) is only valid when PRINter0 or PRINter1 is set as the
:HARDcopy:FORMat type.
Query Syntax
:HARDcopy:FFEed?
The :HARDcopy:FFEed? query returns a flag indicating whether a formfeed
is output at the end of the hardcopy dump.
Return Format
<ffeed><NL>
<ffeed> ::= {0 | 1}
See Also • "Introduction to :HARDcopy Commands" on page 246
• ":HARDcopy:STARt" on page 255
• ":HARDcopy:FACTors" on page 249
• ":HARDcopy:INKSaver" on page 251
• ":HARDcopy:LAYout" on page 252
• ":HARDcopy:PALette" on page 253
To Next Page
Loading...
