Agilent Technologies InfiniiVision 5000 Series

114 Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide
5 Commands by Subsystem
*SAV (Save)
(see page 658)
Command Syntax
*SAV <value>
<value> ::= {0|1|2|3|4|5|6|7|8|9}
The *SAV command stores the current state of the instrument in a save
register. The data parameter specifies the register where the data will be
saved.
See Also • "Introduction to Common (*) Commands" on page 99
• "*RCL (Recall)" on page 110