372 Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide
5 Commands by Subsystem
:SAVE:WAVeform:SEGMented
(see page 658)
Command Syntax
:SAVE:WAVeform:SEGMented <option>
<option> ::= {ALL | CURRent}
When segmented memory is used for acquisitions, the
:SAVE:WAVeform:SEGMented command specifies which segments are
included when the waveform is saved:
• ALL — all acquired segments are saved.
• CURRent — only the currently selected segment is saved.
Query Syntax
:SAVE:WAVeform:SEGMented?
The :SAVE:WAVeform:SEGMented? query returns the current segmented
waveform save option setting.
Return Format
<option><NL>
<option> ::= {ALL | CURR}
See Also • "Introduction to :SAVE Commands" on page 358
• ":SAVE:WAVeform[:STARt]" on page 369
• ":SAVE:WAVeform:FORMat" on page 370
• ":SAVE:WAVeform:LENGth" on page 371
To Next Page
Loading...
