To Next Page

To Previous Page

140 Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide

5 Commands by Subsystem

:MERGe

(see page 658)

Command Syntax

:MERGe <pixel memory>

<pixel memory> ::= {PMEMory0 | PMEMory1 | PMEMory2 | PMEMory3

| PMEMory4 | PMEMory5 | PMEMory6 | PMEMory7

| PMEMory8 | PMEMory9}

The :MERGe command stores the contents of the active display in the

specified pixel memory. The previous contents of the pixel memory are

overwritten. The pixel memories are PMEMory0 through PMEMory9. This

command is similar to the function of the "Save To: INTERN_<n>" key in

the Save/Recall menu.

See Also • "Introduction to Root (:) Commands" on page 124

• "*SAV (Save)" on page 114

• "*RCL (Recall)" on page 110

• ":VIEW" on page 162

• ":BLANk" on page 130

Agilent Technologies InfiniiVision 5000 Series Programmer's Guide

Other manuals for Agilent Technologies InfiniiVision 5000 Series