To Next Page

To Previous Page

Commands by Subsystem 5

Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide 381

:SBUS:IIC:ASIZe

(see page 658)

Command Syntax

:SBUS:IIC:ASIZe <size>

<size> ::= {BIT7 | BIT8}

The :SBUS:IIC:ASIZe command determines whether the Read/Write bit is

included as the LSB in the display of the IIC address field of the decode

bus.

Query Syntax

:SBUS:IIC:ASIZe?

The :SBUS:IIC:ASIZe? query returns the current IIC address width setting.

Return Format

<mode> ::= {BIT7 | BIT8}

Errors • "- 241, Hardware missing" on page 617

See Also • "Introduction to :SBUS Commands" on page 374

• ":TRIGger:IIC Commands" on page 453

NOTE

This command is only valid on 4 (analog) channel oscilloscope models when the low-speed

IIC and SPI serial decode option (Option LSS) has been licensed.

Agilent Technologies InfiniiVision 5000 Series Programmer's Guide

Other manuals for Agilent Technologies InfiniiVision 5000 Series