Commands by Subsystem 5
Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide 369
:SAVE:WAVeform[:STARt]
(see page 658)
Command Syntax
:SAVE:WAVeform[:STARt] [<file_name>]
<file_name> ::= quoted ASCII string
The :SAVE:WAVeform[:STARt] command saves oscilloscope waveform data
to a file.
See Also • "Introduction to :SAVE Commands" on page 358
• ":SAVE:WAVeform:FORMat" on page 370
• ":SAVE:WAVeform:LENGth" on page 371
• ":SAVE:FILename" on page 359
• ":RECall:SETup[:STARt]" on page 356
NOTE
If a file extension is provided as part of a specified <file_name>, and it does not match the
extension expected by the format specified in :SAVE:WAVeform:FORMat, the format will be
changed if the extension is a valid waveform file extension.
To Next Page
Loading...
