Agilent Technologies InfiniiVision 5000 Series

Commands by Subsystem 5
Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide 353
:RECall:IMAGe[:STARt]
(see page 658)
Command Syntax
:RECall:IMAGe[:STARt] [<file_spec>]
<file_spec> ::= {<internal_loc> | <file_name>}
<internal_loc> ::= 0-9; an integer in NR1 format
<file_name> ::= quoted ASCII string
The :RECall:IMAGe[:STARt] command recalls a trace (TIFF) image.
See Also • "Introduction to :RECall Commands" on page 351
• ":RECall:FILename" on page 352
• ":SAVE:IMAGe[:STARt]" on page 360
NOTE
If a file extension is provided as part of a specified <file_name>, it must be ".tif".