Agilent Technologies InfiniiVision 5000 Series

Commands by Subsystem 5
Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide 115
*SRE (Service Request Enable)
(see page 658)
Command Syntax
*SRE <mask>
<mask> ::= integer with values defined in the following table.
The *SRE command sets the bits in the Service Request Enable Register.
The Service Request Enable Register contains a mask value for the bits to
be enabled in the Status Byte Register. A one in the Service Request
Enable Register enables the corresponding bit in the Status Byte Register.
A zero disables the bit.
Table 32 Service Request Enable Register (SRE)
Bit Name Description When Set (1 = High = True), Enables:
7 OPER Operation Status Register Interrupts when enabled conditions in the
Operation Status Register (OPER) occur.
6 --- --- (Not used.)
)URP
2SHUDWLRQ
6WDWXV
5HJLVWHUV


23(5 75*0$9(6%
546
066
75*
5HJ
7(5" 7ULJJHU(YHQW5HJLVWHU
65(
65("
67%" 6WDWXV%\WH5HJLVWHU
6HUYLFH5HTXHVW(QDEOH
0DVN5HJLVWHU
2XWSXW
4XHXH
654
)URP
6WDQGDUG
(YHQW
6WDWXV
5HJLVWHUV
865
06*
6HUYLFH5HTXHVW
25