Agilent Technologies InfiniiVision 5000 Series Programmer's Guide

310 Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide
5 Commands by Subsystem
:MEASure:VMIN
(see page 658)
Command Syntax
:MEASure:VMIN [<source>]
<source> ::= {CHANnel<n> | FUNCtion | MATH}
<n>::={1|2|3|4}forthefour channel oscilloscope models
<n> ::= {1 | 2} for the two channel oscilloscope models
The :MEASure:VMIN command installs a screen measurement and starts a
minimum vertical value measurement. If the optional source parameter is
specified, the current source is modified.
Query Syntax
:MEASure:VMIN? [<source>]
The :MEASure:VMIN? query measures and outputs the minimum vertical
value present on the selected waveform.
Return Format
<value><NL>
<value> ::= minimum vertical value of the selected waveform in
NR3 format
See Also • "Introduction to :MEASure Commands" on page 272
• ":MEASure:SOURce" on page 297
• ":MEASure:VBASe" on page 308
• ":MEASure:VMAX" on page 309
• ":MEASure:VPP" on page 311

Agilent Technologies InfiniiVision 5000 Series Specifications

General

Brand	Agilent Technologies
Model	InfiniiVision 5000 Series
Category	Test Equipment
Language	English