Agilent Technologies InfiniiVision 5000 Series

314 Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide
5 Commands by Subsystem
:MEASure:VTIMe
(see page 658)
Query Syntax
:MEASure:VTIMe? <vtime_argument>[,<source>]
<vtime_argument> ::= time from trigger in seconds
<source> ::= {CHANnel<n> | FUNCtion | MATH}
<n>::={1|2|3|4}forthefour channel oscilloscope models
<n> ::= {1 | 2} for the two channel oscilloscope models
The :MEASure:VTIMe? query returns the value at a specified time on the
source specified with :MEASure:SOURce. The specified time must be on
the screen and is referenced to the trigger event. If the optional source
parameter is specified, the current source is modified.
Return Format
<value><NL>
<value> ::= value at the specified time in NR3 format
See Also • "Introduction to :MEASure Commands" on page 272
• ":MEASure:SOURce" on page 297
• ":MEASure:TEDGe" on page 302
• ":MEASure:TVALue" on page 304
NOTE
This query is not available if the source is FFT (Fast Fourier Transform).