To Next Page

To Previous Page

674 Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide

11 More About Oscilloscope Commands

• :COUNt (see page 519)

• :TTAG (see page 520)

• :SOURce (see page 521)

• :SUBSource (see page 525)

• :TYPE (see page 526)

• :UNSigned (see page 527)

• :VIEW (see page 528)

• :XINCrement (see page 529)

• :XORigin (see page 530)

• :XREFerence (see page 531)

• :YINCrement (see page 532)

• :YORigin (see page 533)

• :YREFerence (see page 534)

Common

Commands (IEEE

488.2)

• *CLS (see page 101)

• *ESE (see page 102)

• *ESR (see page 104)

• *IDN (see page 106)

• *LRN (see page 107)

• *OPC (see page 108)

• *OPT (see page 109)

• *RCL (see page 110)

• *RST (see page 111)

• *SAV (see page 114)

• *SRE (see page 115)

• *STB (see page 117)

• *TRG (see page 119)

• *TST (see page 120)

• *WAI (see page 121)

Duplicate Mnemonics

Identical function mnemonics can be used in more than one subsystem.

For example, the function mnemonic RANGe may be used to change the

vertical range or to change the horizontal range:

:CHANnel1:RANGe .4

Sets the vertical range of channel 1 to 0.4 volts full scale.

Agilent Technologies InfiniiVision 5000 Series Programmer's Guide

Other manuals for Agilent Technologies InfiniiVision 5000 Series