To Next Page

To Previous Page

456 Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide

5 Commands by Subsystem

:TRIGger:IIC:PATTern:DATa2

(see page 658)

Command Syntax

:TRIGger:IIC:PATTern:DATa2 <value>

<value> ::= integer or <string>

<string> ::= "0xnn" where n ::= {0,..,9 | A,..,F}

The :TRIGger:IIC:PATTern:DATa2 command sets IIC data 2. The data value

can range from 0x00 to 0x0FF (hexadecimal). Use the don't care data

pattern (- 1 or 0xFFFFFFFF) to ignore the data value.

Query Syntax

:TRIGger:IIC:PATTern:DATa2?

The :TRIGger:IIC:PATTern:DATa2? query returns the current pattern for IIC

data 2.

Return Format

See Also • "Introduction to :TRIGger Commands" on page 411

• ":TRIGger:IIC:PATTern:ADDRess" on page 454

• ":TRIGger:IIC:PATTern:DATA" on page 455

• ":TRIGger:IIC:TRIGger[:TYPE]" on page 460

Agilent Technologies InfiniiVision 5000 Series Programmer's Guide

Other manuals for Agilent Technologies InfiniiVision 5000 Series