Agilent Technologies InfiniiVision 5000 Series Programmer's Guide

210 Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide
5 Commands by Subsystem
:DISPlay:CLEar
(see page 658)
Command Syntax
:DISPlay:CLEar
The :DISPlay:CLEar command clears the display and resets all associated
measurements. If the oscilloscope is stopped, all currently displayed data
is erased. If the oscilloscope is running, all of the data for active channels
and functions is erased; however, new data is displayed on the next
acquisition.
See Also • "Introduction to :DISPlay Commands" on page 208
• ":CDISplay" on page 131

Agilent Technologies InfiniiVision 5000 Series Specifications

General

Brand	Agilent Technologies
Model	InfiniiVision 5000 Series
Category	Test Equipment
Language	English