Agilent Technologies InfiniiVision 5000 Series Programmer's Guide

134 Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide
5 Commands by Subsystem
:HWEenable (Hardware Event Enable Register)
(see page 658)
Command Syntax
:HWEenable <mask>
<mask> ::= 16-bit integer
The :HWEenable command sets a mask in the Hardware Event Enable
register. Set any of the following bits to "1" to enable bit 12 in the
Operation Status Condition Register and potentially cause an SRQ (Service
Request interrupt to be generated.
Query Syntax
:HWEenable?
The :HWEenable? query returns the current value contained in the
Hardware Event Enable register as an integer number.
Return Format
<value><NL>
<value> ::= integer in NR1 format.
See Also • "Introduction to Root (:) Commands" on page 124
7R+:(ELWLQ
2SHUDWLRQ6WDWXV
&RQGLWLRQ5HJLVWHU

25
+:(5HJLVWHU&21'LWLRQ"
+DUGZDUH(YHQW&RQGLWLRQ5HJLVWHU
+:(HQDEOH
+:(HQDEOH"
+DUGZDUH(YHQW(QDEOH0DVN5HJLVWHU


+:(5HJLVWHU>(9(1W@"
+DUGZDUH(YHQW(YHQW5HJLVWHU
3//
/RFNHG
3//
/RFNHG

Table 35 Hardware Event Enable Register (HWEenable)
Bit Name Description When Set (1 = High = True), Enables:
15-13 --- --- (Not used.)
12 PLL
Locked
PLL Locked This bit is for internal use and is not intended
for general use.
11-0 --- --- (Not used.)

Agilent Technologies InfiniiVision 5000 Series Specifications

General

Brand	Agilent Technologies
Model	InfiniiVision 5000 Series
Category	Test Equipment
Language	English