Commands by Subsystem 5
Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide 131
:CDISplay
(see page 658)
Command Syntax
:CDISplay
The :CDISplay command clears the display and resets all associated
measurements. If the oscilloscope is stopped, all currently displayed data
is erased. If the oscilloscope is running, all the data in active channels and
functions is erased; however, new data is displayed on the next
acquisition.
See Also • "Introduction to Root (:) Commands" on page 124
• ":DISPlay:CLEar" on page 210
To Next Page
Loading...
