Commands by Subsystem 5
Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide 533
:WAVeform:YORigin
(see page 658)
Query Syntax
:WAVeform:YORigin?
The :WAVeform:YORigin? query returns the y- origin value for the currently
specified source. This value is the Y- axis value of the data value specified
by the :WAVeform:YREFerence value. For this product, this is the Y- axis
value of the center of the screen.
Return Format
<value><NL>
<value> ::= y-origin in the current preamble in 32-bit
floating point NR3 format
See Also • "Introduction to :WAVeform Commands" on page 502
• ":WAVeform:PREamble" on page 516
• ":WAVeform:YREFerence" on page 534
Example Code • "Example Code" on page 517
To Next Page
Loading...
