528 Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide
5 Commands by Subsystem
:WAVeform:VIEW
(see page 658)
Command Syntax
:WAVeform:VIEW <view>
<view> ::= {MAIN}
The :WAVeform:VIEW command sets the view setting associated with the
currently selected waveform. Currently, the only legal value for the view
setting is MAIN.
Query Syntax
:WAVeform:VIEW?
The :WAVeform:VIEW? query returns the view setting associated with the
currently selected waveform.
Return Format
<view><NL>
<view> ::= {MAIN}
See Also • "Introduction to :WAVeform Commands" on page 502
• ":WAVeform:POINts" on page 512
To Next Page
Loading...
