Commands by Subsystem 5
Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide 387
:SBUS:UART:COUNt:RESet
(see page 658)
Command Syntax
:SBUS:UART:COUNt:RESet
Resets the UART frame counters.
Errors • "- 241, Hardware missing" on page 617
See Also • ":SBUS:UART:COUNt:ERRor" on page 386
• ":SBUS:UART:COUNt:RXFRames" on page 388
• ":SBUS:UART:COUNt:TXFRames" on page 389
• "Introduction to :SBUS Commands" on page 374
• ":SBUS:MODE" on page 383
• ":TRIGger:UART Commands" on page 485
NOTE
This command is only valid on 4 (analog) channel oscilloscope models when the
UART/RS-232 triggering and serial decode option (Option 232) has been licensed.
To Next Page
Loading...
