Agilent Technologies InfiniiVision 5000 Series

Commands by Subsystem 5
Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide 383
:SBUS:MODE
(see page 658)
Command Syntax
:SBUS:MODE <mode>
<mode> ::= {IIC | SPI | CAN | LIN | UART}
The :SBUS:MODE command determines the decode mode for the serial
bus.
Query Syntax
:SBUS:MODE?
The :SBUS:MODE? query returns the current serial bus decode mode
setting.
Return Format
<mode><NL>
<mode> ::= {IIC | SPI | CAN | LIN | UART | NONE}
Errors • "- 241, Hardware missing" on page 617
See Also • "Introduction to :SBUS Commands" on page 374
• ":TRIGger:MODE" on page 417
• ":TRIGger:IIC Commands" on page 453
• ":TRIGger:SPI Commands" on page 470
• ":TRIGger:CAN Commands" on page 422
• ":TRIGger:LIN Commands" on page 462
• ":TRIGger:UART Commands" on page 485
NOTE
This command is only valid on 4 (analog) channel oscilloscope models when a serial decode
option has been licensed.