Agilent Technologies InfiniiVision 5000 Series

Commands by Subsystem 5
Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide 205
:CHANnel<n>:SCALe
(see page 658)
Command Syntax
:CHANnel<n>:SCALe <scale>[<suffix>]
<scale> ::= vertical units per division in NR3 format
<suffix> ::= {V | mV}
<n>::={1|2|3|4}forthefour channel oscilloscope models
<n> ::= {1 | 2} for the two channel oscilloscope models
The :CHANnel<n>:SCALe command sets the vertical scale, or units per
division, of the selected channel. When using 1:1 probe attenuation, legal
values for the scale range from:
• 2 mV to 5 V.
If the probe attenuation is changed, the scale value is multiplied by the
probe's attenuation factor.
Query Syntax
:CHANnel<n>:SCALe?
The :CHANnel<n>:SCALe? query returns the current scale setting for the
specified channel.
Return Format
<scale value><NL>
<scale value> ::= vertical units per division in NR3 format
See Also • "Introduction to :CHANnel<n> Commands" on page 190
• ":CHANnel<n>:RANGe" on page 204
• ":CHANnel<n>:PROBe" on page 199