Agilent Technologies InfiniiVision 5000 Series

494 Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide
5 Commands by Subsystem
:TRIGger:UART:POLarity
(see page 658)
Command Syntax
:TRIGger:UART:POLarity <polarity>
<polarity> ::= {HIGH | LOW}
The :TRIGger:UART:POLarity command selects the polarity as idle low or
idle high for the serial decoder and/or trigger when in UART mode.
Query Syntax
:TRIGger:UART:POLarity?
The :TRIGger:UART:POLarity? query returns the current UART polarity
setting.
Return Format
<polarity><NL>
<polarity> ::= {HIGH | LOW}
See Also • "Introduction to :TRIGger Commands" on page 411
• ":TRIGger:MODE" on page 417
• ":TRIGger:UART:TYPE" on page 498