To Next Page

To Previous Page

Obsolete and Discontinued Commands 7

Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide 591

:MEASure:TSTArt

(see page 658)

Command Syntax

:MEASure:TSTArt <value> [suffix]

<value> ::= time at the start marker in seconds

[suffix] ::= {s | ms | us | ns | ps}

The :MEASure:TSTArt command moves the start marker (X1 cursor) to the

specified time with respect to the trigger time.

Query Syntax

:MEASure:TSTArt?

The :MEASure:TSTArt? query returns the time at the start marker (X1

cursor).

Return Format

<value> ::= time at the start marker in NR3 format

See Also • "Introduction to :MARKer Commands" on page 257

• "Introduction to :MEASure Commands" on page 272

• ":MARKer:X1Position" on page 259

• ":MARKer:X2Position" on page 261

• ":MARKer:XDELta" on page 263

• ":MEASure:TDELta" on page 587

• ":MEASure:TSTOp" on page 592

NOTE

The short form of this command, TSTA, does not follow the defined Long Form to Short

Form Truncation Rules (see page 660). The normal short form "TST" would be the same for

both TSTArt and TSTOp, so sending TST for the TSTArt command produces an error.

NOTE

The :MEASure:TSTArt command is an obsolete command provided for compatibility to

previous oscilloscopes. Use the :MARKer:X1Position command (see page 259) instead.

Agilent Technologies InfiniiVision 5000 Series Programmer's Guide

Other manuals for Agilent Technologies InfiniiVision 5000 Series