Agilent Technologies InfiniiVision 5000 Series

Commands by Subsystem 5
Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide 449
:TRIGger:GLITch:POLarity
(see page 658)
Command Syntax
:TRIGger:GLITch:POLarity <polarity>
<polarity> ::= {POSitive | NEGative}
The :TRIGger:GLITch:POLarity command sets the polarity for the glitch
pulse width trigger.
Query Syntax
:TRIGger:GLITch:POLarity?
The :TRIGger:GLITch:POLarity? query returns the glitch pulse width trigger
polarity.
Return Format
<polarity><NL>
<polarity> ::= {POS | NEG}
See Also • "Introduction to :TRIGger Commands" on page 411
• ":TRIGger:MODE" on page 417
• ":TRIGger:GLITch:SOURce" on page 452