Agilent Technologies InfiniiVision 5000 Series Programmer's Guide

592 Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide
7 Obsolete and Discontinued Commands
:MEASure:TSTOp
(see page 658)
Command Syntax
:MEASure:TSTOp <value> [suffix]
<value> ::= time at the stop marker in seconds
[suffix] ::= {s | ms | us | ns | ps}
The :MEASure:TSTOp command moves the stop marker (X2 cursor) to the
specified time with respect to the trigger time.
Query Syntax
:MEASure:TSTOp?
The :MEASure:TSTOp? query returns the time at the stop marker (X2
cursor).
Return Format
<value><NL>
<value> ::= time at the stop marker in NR3 format
See Also • "Introduction to :MARKer Commands" on page 257
• "Introduction to :MEASure Commands" on page 272
• ":MARKer:X1Position" on page 259
• ":MARKer:X2Position" on page 261
• ":MARKer:XDELta" on page 263
• ":MEASure:TDELta" on page 587
• ":MEASure:TSTArt" on page 591
NOTE
The short form of this command, TSTO, does not follow the defined Long Form to Short
Form Truncation Rules (see page 660). The normal short form "TST" would be the same for
both TSTArt and TSTOp, so sending TST for the TSTOp command produces an error.
NOTE
The :MEASure:TSTOp command is an obsolete command provided for compatibility to
previous oscilloscopes. Use the :MARKer:X2Position command (see page 261) instead.

Agilent Technologies InfiniiVision 5000 Series Specifications

General

Brand	Agilent Technologies
Model	InfiniiVision 5000 Series
Category	Test Equipment
Language	English