492 Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide
5 Commands by Subsystem
:TRIGger:UART:IDLE
(see page 658)
Command Syntax
:TRIGger:UART:IDLE <time_value>
<time_value> ::= time from 1 us to 10 s in NR3 format
The :TRIGger:UART:IDLE command selects the value of the idle period for
burst trigger in the range from 1 us to 10 s when in UART mode.
Query Syntax
:TRIGger:UART:IDLE?
The :TRIGger:UART:IDLE? query returns the current UART trigger idle
period time.
Return Format
<time_value><NL>
<time_value> ::= time from 1 us to 10 s in NR3 format
See Also • "Introduction to :TRIGger Commands" on page 411
• ":TRIGger:MODE" on page 417
• ":TRIGger:UART:BURSt" on page 490
• ":TRIGger:UART:TYPE" on page 498
To Next Page
Loading...
