Agilent Technologies InfiniiVision 5000 Series

Commands by Subsystem 5
Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide 493
:TRIGger:UART:PARity
(see page 658)
Command Syntax
:TRIGger:UART:PARity <parity>
<parity> ::= {EVEN | ODD | NONE}
The :TRIGger:UART:PARity command selects the parity to be used with
each message "byte" for the serial decoder and/or trigger when in UART
mode.
Query Syntax
:TRIGger:UART:PARity?
The :TRIGger:UART:PARity? query returns the current UART parity setting.
Return Format
<parity><NL>
<parity> ::= {EVEN | ODD | NONE}
See Also • "Introduction to :TRIGger Commands" on page 411
• ":TRIGger:MODE" on page 417
• ":TRIGger:UART:TYPE" on page 498