To Next Page

To Previous Page

316 Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide

5 Commands by Subsystem

:MEASure:XMAX

(see page 658)

Command Syntax

:MEASure:XMAX [<source>]

<source> ::= {CHANnel<n> | FUNCtion | MATH}

<n>::={1|2|3|4}forthefour channel oscilloscope models

<n> ::= {1 | 2} for the two channel oscilloscope models

The :MEASure:XMAX command installs a screen measurement and starts

an X-at- Max-Y measurement on the selected window. If the optional

source parameter is specified, the current source is modified.

Query Syntax

:MEASure:XMAX? [<source>]

The :MEASure:XMAX? query measures and returns the horizontal axis

value at which the maximum vertical value occurs. If the optional source

is specified, the current source is modified. If all channels are off, the

query returns 9.9E+37.

Return Format

<value> ::= horizontal value of the maximum in NR3 format

See Also • "Introduction to :MEASure Commands" on page 272

• ":MEASure:XMIN" on page 317

• ":MEASure:TMAX" on page 589

NOTE

:MEASure:XMAX is an alias for :MEASure:TMAX.

Agilent Technologies InfiniiVision 5000 Series Programmer's Guide

Other manuals for Agilent Technologies InfiniiVision 5000 Series