Agilent Technologies InfiniiVision 5000 Series

Commands by Subsystem 5
Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide 377
:SBUS:CAN:COUNt:RESet
(see page 658)
Command Syntax
:SBUS:CAN:COUNt:RESet
Resets the frame counters.
Errors • "- 241, Hardware missing" on page 617
See Also • ":SBUS:CAN:COUNt:ERRor" on page 375
• ":SBUS:CAN:COUNt:OVERload" on page 376
• ":SBUS:CAN:COUNt:TOTal" on page 378
• ":SBUS:CAN:COUNt:UTILization" on page 379
• "Introduction to :SBUS Commands" on page 374
• ":SBUS:MODE" on page 383
• ":TRIGger:CAN Commands" on page 422