To Next Page

To Previous Page

Obsolete and Discontinued Commands 7

Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide 597

:MEASure:VSTArt

(see page 658)

Command Syntax

:MEASure:VSTArt <vstart_argument>

<vstart_argument> ::= value for vertical marker 1

The :MEASure:VSTArt command moves the vertical marker (Y1 cursor) to

the specified value corresponding to the selected source. The source can

be selected by the MARKer:X1Y1source command.

Query Syntax

:MEASure:VSTArt?

The :MEASure:VSTArt? query returns the current value of the Y1 cursor.

Return Format

<value> ::= voltage at voltage marker 1 in NR3 format

See Also • "Introduction to :MARKer Commands" on page 257

• "Introduction to :MEASure Commands" on page 272

• ":MARKer:Y1Position" on page 264

• ":MARKer:Y2Position" on page 265

• ":MARKer:YDELta" on page 266

• ":MARKer:X1Y1source" on page 260

• ":MEASure:SOURce" on page 297

• ":MEASure:TDELta" on page 587

• ":MEASure:TSTArt" on page 591

NOTE

The short form of this command, VSTA, does not follow the defined Long Form to Short

Form Truncation Rules (see page 660). The normal short form, VST, would be the same for

both VSTArt and VSTOp, so sending VST for the VSTArt command produces an error.

NOTE

The :MEASure:VSTArt command is an obsolete command provided for compatibility to

previous oscilloscopes. Use the :MARKer:Y1Position command (see page 264) instead.

Agilent Technologies InfiniiVision 5000 Series Programmer's Guide

Other manuals for Agilent Technologies InfiniiVision 5000 Series