Commands by Subsystem 5
Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide 499
:TRIGger:UART:WIDTh
(see page 658)
Command Syntax
:TRIGger:UART:WIDTh <width>
<width> ::= {5|6|7|8|9}
The :TRIGger:UART:WIDTh command determines the number of bits (5- 9)
for each message "byte" for the serial decoder and/or trigger when in
UART mode.
Query Syntax
:TRIGger:UART:WIDTh?
The :TRIGger:UART:WIDTh? query returns the current UART width setting.
Return Format
<width><NL>
<width> ::= {5|6|7|8|9}
See Also • "Introduction to :TRIGger Commands" on page 411
• ":TRIGger:MODE" on page 417
• ":TRIGger:UART:TYPE" on page 498
To Next Page
Loading...
