328 Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide
5 Commands by Subsystem
:MTESt:COUNt:FWAVeforms
(see page 658)
Query Syntax
:MTESt:COUNt:FWAVeforms? [CHANnel<n>]
<n>::={1|2|3|4}forthefour channel oscilloscope models
<n> ::= {1 | 2} for the two channel oscilloscope models
The :MTESt:COUNt:FWAVeforms? query returns the total number of failed
waveforms in the current mask test run. This count is for all regions and
all waveforms.
Return Format
<failed><NL>
<failed> ::= number of failed waveforms in NR1 format.
See Also • "Introduction to :MTESt Commands" on page 320
• ":MTESt:COUNt:WAVeforms" on page 331
• ":MTESt:COUNt:TIME" on page 330
• ":MTESt:COUNt:RESet" on page 329
• ":MTESt:SOURce" on page 349
Example Code • "Example Code" on page 320
To Next Page
Loading...
