Agilent Technologies InfiniiVision 5000 Series

296 Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide
5 Commands by Subsystem
:MEASure:SHOW
(see page 658)
Command Syntax
:MEASure:SHOW <show>
<show> ::= {1 | ON}
The :MEASure:SHOW command enables markers for tracking measurements
on the display. This feature is always on.
Query Syntax
:MEASure:SHOW?
The :MEASure:SHOW? query returns the current state of the markers.
Return Format
<show><NL>
<show> ::= 1
See Also • "Introduction to :MEASure Commands" on page 272