Obsolete and Discontinued Commands 7
Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide 605
:MTESt:{STARt | STOP}
(see page 658)
Command Syntax
:MTESt:{STARt | STOP}
The :MTESt:{STARt | STOP} command starts or stops the acquisition
system.
See Also • "Introduction to :MTESt Commands" on page 320
NOTE
The :MTESt:STARt and :MTESt:STOP commands are obsolete and are provided for
backward compatibility to previous oscilloscopes. Use the :RUN command (see page 156)
and :STOP command (see page 160) instead.
To Next Page
Loading...
