To Next Page

To Previous Page

Commands by Subsystem 5

Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide 325

:MTESt:AMASk:UNITs

(see page 658)

Command Syntax

:MTESt:AMASk:UNITs <units>

<units> ::= {CURRent | DIVisions}

The :MTESt:AMASk:UNITs command alters the way the mask test

subsystem interprets the tolerance parameters for automasking as defined

by :MTESt:AMASk:XDELta and :MTESt:AMASk:YDELta commands.

• CURRent — the mask test subsystem uses the units as set by the

:CHANnel<n>:UNITs command, usually time for

∆X and voltage for ∆Y.

• DIVisions — the mask test subsystem uses the graticule as the

measurement system, so tolerance settings are specified as parts of a

screen division. The mask test subsystem maintains separate XDELta

and YDELta settings for CURRent and DIVisions. Thus, XDELta and

YDELta are not converted to new values when the UNITs setting is

changed.

Query Syntax

:MTESt:AMASk:UNITs?

The :MTESt:AMASk:UNITs query returns the current measurement units

setting for the mask test automask feature.

Return Format

<units> ::= {CURR | DIV}

See Also • "Introduction to :MTESt Commands" on page 320

• ":MTESt:AMASk:XDELta" on page 326

• ":MTESt:AMASk:YDELta" on page 327

• ":CHANnel<n>:UNITs" on page 206

• ":MTESt:AMASk:SOURce" on page 324

• ":MTESt:SOURce" on page 349

Example Code • "Example Code" on page 320

Agilent Technologies InfiniiVision 5000 Series Programmer's Guide

Other manuals for Agilent Technologies InfiniiVision 5000 Series