Agilent Technologies InfiniiVision 5000 Series

Commands by Subsystem 5
Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide 385
:SBUS:UART:BASE
(see page 658)
Command Syntax
:SBUS:UART:BASE <base>
<base> ::= {ASCii | BINary | HEX}
The :SBUS:UART:BASE command determines the base to use for the UART
decode display.
Query Syntax
:SBUS:UART:BASE?
The :SBUS:UART:BASE? query returns the current UART decode base
setting.
Return Format
<base><NL>
<base> ::= {ASCii | BINary | HEX}
Errors • "- 241, Hardware missing" on page 617
See Also • "Introduction to :SBUS Commands" on page 374
• ":TRIGger:UART Commands" on page 485
NOTE
This command is only valid on 4 (analog) channel oscilloscope models when the
UART/RS-232 triggering and serial decode option (Option 232) has been licensed.