Agilent Technologies InfiniiVision 5000 Series

366 Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide
5 Commands by Subsystem
:SAVE:MASK[:STARt]
(see page 658)
Command Syntax
:SAVE:MASK[:STARt] [<file_spec>]
<file_spec> ::= {<internal_loc> | <file_name>}
<internal_loc> ::= 0-3; an integer in NR1 format
<file_name> ::= quoted ASCII string
The :SAVE:MASK[:STARt] command saves a mask.
See Also • "Introduction to :SAVE Commands" on page 358
• ":SAVE:FILename" on page 359
• ":RECall:MASK[:STARt]" on page 354
• ":MTESt:DATA" on page 332
NOTE
If a file extension is provided as part of a specified <file_name>, it must be ".msk".