Agilent Technologies InfiniiVision 5000 Series

To Next Page

To Previous Page

452 Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide

5 Commands by Subsystem

:TRIGger:GLITch:SOURce

(see page 658)

Command Syntax

:TRIGger:GLITch:SOURce <source>

<source> ::= {CHANnel<n> | EXTernal}

<n>::={1|2|3|4}forthefour channel oscilloscope models

<n> ::= {1 | 2} for the two channel oscilloscope models

The :TRIGger:GLITch:SOURce command selects the channel that produces

the pulse width trigger.

Query Syntax

:TRIGger:GLITch:SOURce?

The :TRIGger:GLITch:SOURce? query returns the current pulse width

source. If all channels are off, the query returns "NONE."

Return Format

See Also • "Introduction to :TRIGger Commands" on page 411

• ":TRIGger:MODE" on page 417

• ":TRIGger:GLITch:LEVel" on page 448

• ":TRIGger:GLITch:POLarity" on page 449

• ":TRIGger:GLITch:QUALifier" on page 450

• ":TRIGger:GLITch:RANGe" on page 451

Example Code • "Example Code" on page 444

Other manuals for Agilent Technologies InfiniiVision 5000 Series