Agilent Technologies InfiniiVision 5000 Series

Commands by Subsystem 5
Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide 489
:TRIGger:UART:BITorder
(see page 658)
Command Syntax
:TRIGger:UART:BITorder <bitorder>
<bitorder> ::= {LSBFirst | MSBFirst}
The :TRIGger:UART:BITorder command specifies the order of transmission
used by the physical Tx and Rx input signals for the serial decoder and/or
trigger when in UART mode. LSBFirst sets the least significant bit of each
message "byte" as transmitted first. MSBFirst sets the most significant bit
as transmitted first.
Query Syntax
:TRIGger:UART:BITorder?
The :TRIGger:UART:BITorder? query returns the current UART bit order
setting.
Return Format
<bitorder><NL>
<bitorder> ::= {LSBF | MSBF}
See Also • "Introduction to :TRIGger Commands" on page 411
• ":TRIGger:MODE" on page 417
• ":TRIGger:UART:TYPE" on page 498
• ":TRIGger:UART:SOURce:RX" on page 496
• ":TRIGger:UART:SOURce:TX" on page 497